Government’s use of Oracle cloud services are defined by the applicable contract for such services. As such, the use, reproduction, duplication, release, display, disclosure, modification, preparation of derivative works, and/or adaptation of i) Oracle programs (including any operating system, integrated software, any programs embedded, installed or activated on delivered hardware, and modifications of such programs), ii) Oracle computer documentation and/or iii) other Oracle data, is subject to the rights and limitations specified in the license contained in the applicable contract. Government end users are "commercial computer software" or "commercial computer software documentation" pursuant to the applicable Federal Acquisition Regulation and agency-specific supplemental regulations. GOVERNMENT END USERS: Oracle programs (including any operating system, integrated software, any programs embedded, installed or activated on delivered hardware, and modifications of such programs) and Oracle computer documentation or other Oracle data delivered to or accessed by U.S. Government or anyone licensing it on behalf of the U.S. The dovetail button on the end of the piston.Īll taken apart, I'll get it back together later this week.If this is software or related documentation that is delivered to the Don't they have deburring tools in Germany? I'd like to say "carefully", but I ended up skinning one finger on the sharp tube slot edge. There was a serious lack of any lubrication. Spring guide, spacer, cap and the spring. The cap unscrewed fully and the compressor was unscrewed.Ī spacer (which is interesting, I would have thought the spring would have taken up the full length of the tube) and the cap. Unlike the Diana 6, the cap on the 5 holds the spring in. For fine adjustment of the mirror glass use the remote control. (See arrow in Photo) With a driver in the drivers seat rotate the mirror head to the approximate viewing position and tighten the adjustment screws (75-100 in/lbs). The action was clamped in the spring compressor and the locking screw removed.Ī strap wrench was used to unscrew the cap, keeping light pressure against it with the compressor. Loosen the mirror head adjustment screw, located on the mirror base under the mirror head, using a 3/16' hex wrench. The trigger screw has a setscrew inside that adjusts the position of the ball relative to the screw. The trigger adjustment screw (with ball) and locking screw. The piston link was pulled forward and out of the slot.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |